Powerware 5140 Uživatelský manuál stáhnout pdf (Strana 34)

Installation

Powerware

5140 User’s Guide www.powerware.com

Use the following procedure to install the REPO switch:

1. Confirm that the power is off at the main utility breaker.

2. Connect the switch or circuit to the REPO port on the UPS rear

panel using insulated 18 - 20 AWG (0.75 mm

-0.5mm

)wire.

Figure 14. REPO Port

3. Verify that the remote circuit is off.

4. Verify that the REPO switch is in the OFF position to enable

power to the output receptacles.

Option Modules

Option modules help your UPS communicate in a variety of networking

environments and are installed in the UPS option slot. See the manual

that accompanies each module for installation instructions.

Power Distribution Unit

The high-to-low voltage PDU provides 120V output and up to 250 VA

with two low-voltage outlets (see Figure 15). Use the IEC jumper cords

provided with the PDU kit to connect to an IEC-320-C13 receptacle on

the UPS rear panel.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 67 68

Žádné komentáře

Powerware 5140 Uživatelský manuál Strana 34